Installation Details
Easi-Set Models
Easi-Set Precast Buildings are easily transported and installed. Your installation can be completed within a few hours. No foundations or footings are required. Only a level six-inch layer of sand or crushed stone on an approved sub-base are needed to provide adequate support and drainage. It is critical that the stone base be flat for all size buildings to ensure proper installation. Recommended site requirements are attached to the specifications.If there is a requirement for a large number of penetrations or a large opening in the floor, the pre-assembled building can be delivered without a floor. The building can be placed on a poured-in-place slab and attached with expansion anchors. Easi-Set Buildings can be assembled around existing equipment. Site assembled buildings are ideal for sites with narrow or limited access.
Easi-Span Models
Easi-Span Buildings can be ordered with a floor and all site requirements can be taken care of by the building manufacturer if preferred. Easi-Span Buildings are designed to be set on a crushed engineered stone base that provides adequate support and drainage. Recommended site requirements are attached to the specifications. It is critical that the stone base be flat for all size buildings to ensure proper installation. If there is a requirement for a large number of penetrations or a large opening in the floor, the building can be specified without a floor. The building can be placed on a poured-in-place slab and attached with expansion anchors. Easi-Span Buildings are site assembled and delivered to the site as panels. Easi-Span Buildings can be assembled around existing equipment. Due to the panelization, they are easily erected at remote and difficult to access locations, provided there is enough room for a truck and small crane.
Restroom Buildings
Easi-Set/Easi-Span Restrooms are designed to be placed on an engineered crushed stone base that provides adequate support and drainage. Site requirements are attached to all specifications. Pre-assembled buildings can also be set on a poured-in-place slab or a gravel base with openings in the floor for “stub out” pipes or electrical conduit. Field-installed building walls are attached to the slab using expansion anchors. Easi-Set restrooms are designed to be tough and rugged providing years of maintenance-free service.
Vault or Dry restroom buildings require excavation for the underground vault, with an engineered crushed stone base for support and drainage. Easi-Set/Easi-Span Restroom manufacturers will excavate and prepare the base in addition to installing the restroom if required.